cg-header_tel.png0800 202 700

SOLAR, WIND & WATER POWER - INDUSTRIAL GENERATORS

Like-114-365

AUTOMATIC TRANSFER SWITCH

AUTOMATIC TRANSFER SWITCH
A transfer switch is an electrical switch that reconnects electric power source from its primary source to a standby source. Switches may be manually or automatically operated.
An Automatic Transfer Switch (ATS) is often installed where a backup generator is located, so that the generator may provide temporary electrical power if the utility source fails.
As well as transferring the load to the backup generator, an ATS also commands the backup generator to start, based on the voltage monitored on the primary supply. The transfer switch isolates the backup generator from the electric utility, when the generator is on and is providing temporary power. 

Reliably transfer loads to emergency sources with automatic transfer switches and non-automatic transfer switches.
Auto changeover switch's are best used in unmanned or remote operations and are more efficient way to operate between different power sources
Generator automatic transfer switch are the most common in industry but  these can be used in applications where houses have a main grid supply and a battery back up system to give isolation from one source to the other manual transfer switches are more common in this situation  
4 pole ATS is common for the Generator supply and 3 pole ATS for the main supply 
New Zealand Automatic Transfer Switches  Click Here for Selection Chart
 
100 amp ATS (Automatic Transfer Switch)
Enquire for price
Enquire

100 amp ATS (Automatic Transfer Switch)

  • MCCB Type Automatic Transfer Switch
  Rated Current 125~225A Voltage 100~600VAC
  •  Extraordinary Modularized ATS Design

  •  Superior Serviceability & Maintenance

  •  ATS-01 Controller—Provides Monitoring &
         Protection with Built-in 168HR Exerciser Timer

  •  TSP-01 Voltage Transformer Module—
         Change Voltage Easily by Plug-In Connectors

  •  BTS—Transfer Switch Built with High Short Circuit
         Breaking Capacity & OCPD

  •  All Modules Connected by Harness with High
         Voltage Withstand Plug-In Connectors

  •  Complies with IEC 60947-6 Requirements
Dealer Discounts Apply 
Full spec Click Here

You might also be interested in ...

125 Amp single phase

125 Amp single phase

Single Phase ATS 125 Amps rating

NZ $1,350.00
excl GST
Enquire
225 AMP ATS  (Automatic Transfer Switch)

225 AMP ATS (Automatic Transfer Switch)

automatic transfer switch.....

Enquire for price Enquire
cg-pre_footer_h-line.jpg
cg-pre_footer_01.jpg   cg-pre_footer_03.jpg cg-pre_footer_06.jpg cg-pre_footer_02.jpg   SMA inverter chargers cg-pre_footer_09.jpg cg-pre_footer_08.jpg